MY TUNING BIKE ID-03 without BOSH 4.9 Lambda Sensor

MY TUNING BIKE: CAN-BUS autotuning for RapidBike EVO/RACING

My Tuning Bike is the new optional application that utilizes the CAN-BUS network and a linear lambda sensor (wide band) to perform real-time self-remapping of the injection.

The difference compared to the self-adaptive tuning already implemented by RapidBike EVO and RACING is the speed at which the remapping is achieved: using the original sensors of the motorcycles (narrow band), the self-adaptive mechanism takes about 2 hours to complete the operation. With My Tuning Bike, the time required is reduced to about 20 minutes.

Furthermore, in cases of motorcycles lacking a lambda sensor, My Tuning Bike represents the only solution for achieving permanent self-remapping.

What the kit includes:

Complete MY TUNING BIKE kit - autotuning management on CAN-BUS without lambda sensor (C27SONDA2 to be purchased separately)

Attention:

The My Tuning Bike kit can be used on motorcycles equipped with 1 to 4 lambda sensors simultaneously. The kits to be used when employing more than 1 system in parallel are different from each other.

Therefore, when needing to purchase 1 My Tuning Bike kit, you must select kit ID-01.

If you need to use 2 systems simultaneously, you must purchase 1 kit ID-01 + 1 kit ID-02.

If you need to use 3 systems simultaneously, you must purchase 1 kit ID-01 + 1 kit ID-02 + 1 kit ID-03.

If you need to use 4 systems simultaneously, you must purchase 1 kit ID-01 + 1 kit ID-02 + 1 kit ID-03 + 1 kit ID-04.

IMPORTANT:

The My Tuning Bike system does NOT work with the stock lambda sensors installed on the motorcycle (which are sensors that measure a simple output voltage) but requires a linear lambda sensor (like the one provided in the kit) that instead measures the stoichiometric ratio. This means that the sensor can be purchased with the My Tuning Bike system or must be purchased separately.

The photo may not fully reflect the shapes and model of the product.