FA ITALIA 179642 MOTORCYCLE BRAKE CABLE

Cable Brake front for Vespa PK50-80 S/Lusso/ PX80-200/PE PK50-80 S/Lusso/ PX80-200/PE/Lusso/T5 with sleeve and pear nipple, FA, l (cable)=1270mm, Ø 1,9mm/6,0mm, l (sleeve)=1150mm, with threaded rod Cables are among the most important spare parts. You should carry a spare set on your scooter and you should also keep a spare set in your garage at home. Snapped cables are an annoyance on every excursion. Cables which are hard to pull take their toll on the nerves and tendons. Frayed cables have to be replaced. For this reason, whether it is a restoration or annual service, replacing the cables on a regular basis is recommended. We only stock high quality cables which we fit to our own scooters. They are available as individual cables, cables with sleeve and optionally also with PTFE sleeve. They differ in terms of their length and diameter and the appearance and colour of the sleeve. Certain throttle, choke and brake cables differ depending on the specific model. Cables with PTFE sleeves are perfect for tight installation radii and are very easy to operate. The interior section of the sleeve has a special lining which has a clearly superior effect on the running and the lifespan of the cable. These cables do not require lubricating either. SIP-TIP: Order screw nipple and new adjusting screws at the same time! Everything apart from PTFE has to be lubricated with oil or grease! Front brake cable:With barrel nipple: For attachment to the front brake lever. With cables that do not have threaded bolts, screw nipple PART No 17727000 and nut PART No 17728000 are required. With pear nipple: For attachment to the front brake lever. Screw nipple for brake lever PART No 62200000 is also required. On cables that do not have threaded bolts, screw nipple PART No 17727000 and nut PART No 17728000 are required. On cables with threaded bolts, adjusting nut PART No 17964100 and cable lead through PART No 17964000 are also required.###179642 (PIAGGIO)