DELLORTO 0226535 08 Carburetor needle

Jet Needle DELL'ORTO D35 for PHBL/VHST carburettor for PHBL/VHST carburettor Together with the mixer tube the jet needle regulates the composition of the mix in the partial load or half throttle ranges. The needles differ in terms of their colour, pattern, internal coating and dimensions. Each of the ranges has a specific effect on the composition of the mix. As a rule, the following applies: The bigger the jet, the richer the mix that results. The bigger the needle, the earlier the mix is enriched. The needle also has 4 clip positions, with which it is possible to determine its position. The higher the clip snaps into place on the needle, the deeper it is immersed in the mixer tube and the leaner the mix is in the half throttle range. If the needle is already in the lowest position and mix is already too rich (evident for instance if the Vespa sounds like a 4-stroke scooter when its slide is half open), then you should choose a thicker needle or a smaller mixer tube. We stock all the needles for the DELL’ORTO PHB series (X1-30 for PHBH, D22-50 for PHBL) and VHS series (K2-98 for VHS- B34LD/QD/38DD/VHSH30CS and D36-53 for VHST 24-28BS) in DELL‘ORTO original equipment manufacturer quality. Conclusion: In this case, patient testing pays off as the carburettor can only work perfectly with a suitable needle. SIP-TIP: Needle clips are often lost. The best idea is to order the replacement clip (part no 43300000) at the same time.###B02265B035 (MALOSSI)